POWDER COATING
Our process
PREPARATION
We start the process by preparing and cleaning the surface to remove oils and dirt to ensure full adhesion.
APPLICATION
The powder is applied using an electrostatic gun, giving the powder a positive charge. The surface being coated is grounded, so the negatively charged particles stick to it.
CURING
The coated part is heated in an oven at high temperatures (350-450f) this melts the powder allowing it to bind to the surface.
Our process
PREPARATION
We start the process by preparing and cleaning the surface to remove oils and dirt to ensure full adhesion.
APPLICATION
The powder is applied using an electrostatic gun, giving the powder a positive charge. The surface being coated is grounded, so the negatively charged particles stick to it.
CURING
The coated part is heated in an oven at high temperatures (350-450f) this melts the powder allowing it to bind to the surface.
Our services
- Technical advice on specification requirements
- Indoor & outdoor specifications including marine & offshore
- Quick efficient job turnaround including possible 24 hour turnaround
- Low cost minimum charge for one off’s
- Competitive prices given on all batch quantities
- No colour change charge
- Polyester, Epoxy, Textures, Hammers, Leatherettes & Metallic powders
- All British & European standard colours & gloss levels available
- Non Standard Powders
Our capabilities
We have 2 box ovens which are the following sizes:
- 5.2m x 2.2m x 1.75m
- 3.0m x 2.0m x 1.5m
Re-powders undertaken (including repairs to damaged areas)
Any enclosure can be disassembled, re-powdered (in any BS or RAL colour including a two colour finish) and then reassembled.
